Your shopping cart is empty.

Stainless Steel - To Paint or Not To Paint?

Last Updated: 15/12/20 at 7:50am

Author: Jamie Hunt

Img 78552 E1413176729859 225x300

Well it partly depends on HOW you paint.

Stainless steel needs oxygen to repair its chromium oxide passive film which prevents corrosion. So not painting stainless steel is best. Not painting gives good exposure to oxygen to repair itself if any salt or contaminants get on it – so long as the stainless is maintained (washed every so often, if used externally) and of a suitable stainless grade and finish.

So for fittings and fasteners on the exterior of houses near the coast this would mean stainless steel grade 316 and ideally polished (ouch to the eyes!).

Painting and sealing stainless is fine and ok but this would mean a paint ‘system’ which includes an etch primer and epoxy paint, to ensure salt and other corrosive agents don’t get in.  

The risk you run with slapping some acrylic paint over stainless is that:

a) If it is for exterior use, the contaminants can get through the paint, it doesn’t get any rain water or washing and the stainless under the paint could rust and leach through.

b) You get away with no rust or tea-staining but the stainless was not etched and the paint eventually can peel off.

Although virtually any type of paint will bond to a properly prepared stainless steel surface, a two part epoxy paint is the preferred coating – here is a great guide on how to paint stainless steel.

As far as using stainless fasteners in timber construction goes, research shows that it corrodes less than other metals in wood and that stainless steel is the preferred metal to use in treated timber. So stainless steel is a great metal of choice.

NB: This information is provided as a guide only and Anzor does not accept liability for the application of this information. For advice about stainless steel contact the Nickel Institute


About Jamie Hunt

Jamie Hunt is the CEO of Anzor Fasteners Ltd, with 24 years for procurement and supply of Stainless Steel Fasteners and Hardware under his belt. He also has Olympic yachting experience and is a Certified ISSF Stainless Specialist.

Jamie is a member of the New Zealand Stainless Steel Development Association and has written many articles including "The Stainless Steel Guide", "Can you paint stainless steel?" and "Are stainless fasteners OK with treated timber?". Check out Jamie on his LinkedIn profile for more information.

Anzor Wallchart

Wall Chart

Request a copy of our Engineering & Marine, or Construction Wall Chart.

Anzor Catalogues

Standard Catalogues

Click here to download a PDF of our Engineering Catalogue. This catalogue includes stainless fasteners and fittings, marine hardware and construction brackets.

Anzor Catalogues

Construction Catalogues

Click here dot download a PDF of our Construction Catalogue. This catalogue includes stainless/galvanized fasteners and fittings, and construction brackets.

You are subscribed to push notifications but they are not enabled in your browser.
Please either enable push notifications here or unsubscribe here.