• 316 stainless steel or higher
• C1/C2 seismic rating
• For external use with 50 Year Design Life when used as described in ETA
• Meets BPIR regulation
• Quick and easier assembly without the need for drill hole cleaning (M8-M24).
• Numerous approval certificates for different substrate materials (concrete C12/15-C80/90, steel fiber concrete, solid sand-lime brick) increase the number of applications and fields of use.
• With the new assessment (ETA), the tensile strengths increase decisively. As a result, fewer fixing points and anchors are required.
• The new ETA confirms the use of the FAZ II Plus for dynamic loads for diameters M16-M24.
• The fast installation process of the FAZ II Plus provides an efficient fixing solution for dynamic applications with low load cycles (M16-24) with an immediately loadable fixing point.
• The ETA evaluation, together with other test reports (RWS, ZTV, ETK), ensures high loads in case of fire.
• An external independent assessment confirms the service life of anchorages up to 120 years. Thus, the FAZ II Plus outlasts a whole century and is perfectly suited for large, long-lasting construction projects (M10-M16).
• The FAZ II Plus allows the absorption of high seismic loads of performance category C1 and C2 for diameters M10-M24 with and without the use of the filling disc FFD at installation.
• The variable anchorage depths allow a millimetre-accurate adjustment to the loads.
• The first bolt anchor M6 with ETA evaluation option 1 ensures a safe and approved anchorage.

Applications

• Steel constructions
• Guard rails
• Consoles
• Tunnels
• Lifts
• Lifting platforms
• Conveyor belts
• Pumps
• Ladders
• Cable trays
• Machines
• Staircases
• Façades
• Timber constructions

Building materials

Approved for:

• Concrete C20/25 to C50/60, cracked and non-cracked

Also suitable for:

• Concrete C12/15 - C80/95 (classification available)
• Steel fiber concrete (classification available)
• Solid sand-lime brick (classification available)

You can find detailed information on building materials in the approval document.

Approval

• ETA-19/0520
• ETA-20/0897
• DoP No. 0334
• DoP No. 0337
• 3023222
• ESR-2948
• BZS D 23-607

• The FAZ II Plus is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread.
• When applying the torque, the cone bolt is pulled into the expansion sleeve and expands it against the drill hole wall.
• The anchor is set in line with the approval once the preset installation torque is achieved.
• In the case of series installation, we recommend using the FABS or FA-ST II anchor bolt setting tools.
• In case of seismic demands, the annular gap can be filled using the filling disc FFD.
• For dynamic loads, an additional "dynamic set" is used, which is filled with injection mortar (compressive strength ≥ 50 N/mm² e.g.: FIS V Plus, FIS EM Plus, FIS HB or FIS SB) after installation.
• Visit fischer for Technical Data and Assembly Instructions.

ETA - Concrete

Load Table

Declaration of Performance (DOP)

ICC Certification

Fischer Free Design Software