• Meets BPIR regulation
• 316 stainless
• Star Drive allows for greater torque.
• Heads look uniform across screws, unlike Square Drive heads which need to be lined up to achieve a uniform look.
• Pre-drilling is required but this means driving in the screws is easier on tools and gives a longer battery life than the self drilling type.

Applications

• Commonly used for hardwood decking up to 21mm thick
• Tips for use: Use T20 Max Torsion tip to drive screw.
• Pre-drilling at board ends is required.

Note: Screw length depends on the thickness and type of the material you’re working with. Consult a Licensed Building Practitioner (LBP) to determine the best screw length for your application.

NB: These guidelines should be read in conjunction with the New Zealand Building Code (NZS3602, NZS3604, NZS3605, NZS3640 and NZS4203).

Note: Stainless steel fasteners embedded in high-tannin timbers such as Garapa may cause localised tannin staining on the timber surface. This risk is reduced by using 316 stainless steel screws (rather than 304) and un-coloured screws (rather than bronze or black stainless steel options).

Bronze finish provides a ‘vintage’ look and may wear off in high-traffic areas, with abrasive cleaning, or if damaged during installation.

NB: This information is a guide only. Product selection and installation are the customer’s responsibility, taking into account all specific factors, including timber type and environment. Anzor accepts no liability for the application of this information.

Anzor Stainless Steel Decking Screw Brochure